|
Ok your one of the very lucky who made the smart
choice to purchase a Shepard Hook Replacement.
First check the two axis pins in the rifle to
make sure they are perfectly flush and inserted
all the way.
Now notice the diagram, each notch and hole is
labeled with a letter. Keep this in mind because
I will refer to the notches and holes by their
corresponding designation.
|
 |
|
|
Take
the retaining plate with Notch A facing towards
the front of the rifle. Insert Notch A into the
rifle flush against the left side (opposite side
of the where the selector lever is located) and
insert Notch A into the grove of the Hammer Axis
pin. |
|
Rotate the plate down until
Notch B is inside the Trigger Axis pin's grove
and Hole C is lined up with the Selector Lever
Hole. Make sure Both Notch A and Notch B are inside
there respective axis pin groves. If you installed
it correctly it should look similar to the picture
below.
|
 |
 |
|
|
Take
the selector (safety) lever and reinsert as shown
in the picture. |
|
Make sure the Yoke of the Saftey lever passes
through Hole C. Once reinserted pull the trigger
back and rotate the lever down, if it hits the
back of the disconnector that's ok just force
it a little and it aught to slide past it, continue
to rotate it down until its in the fire position.
|
|
| If you
did every thing correctly is should look similar
to the picture below. |
|
|
| And that's
it, you just completely reinstalled the rifles Fire
Control Group. Put the rifle back together and it
should be ready to rock and roll. |
| Go
to go back to Page 1of Tutorial |
